Microstructural Analysis of Details Obtained by Liquefying Gray Cast Iron in a Sand – Clay Mold

Jamshidbek  Khasanov; Nodir  Turakhodjaev; Abbos  Abdukarimov; Sherzod  Mirkamalov

doi:10.17605/OSF.IO/BS4W2

Jamshidbek Khasanov PhD researcher at Andijan Machine – Building Institute, Andijan, Uzbekistan
Nodir Turakhodjaev DSc. professor at Tashkent State Technical University, Tashkent, Uzbekistan
Abbos Abdukarimov Master student at Tashkent State Technical University, Tashkent, Uzbekistan
Sherzod Mirkamalov Master student at Tashkent State Technical University, Tashkent, Uzbekistan

DOI: https://doi.org/10.17605/OSF.IO/BS4W2

Keywords: cast iron, gray cast iron, SCH24, JSM – IT200, Axiovert 40 MAT, fluidization, casting, pearlite, ferrite, copper phospite, ferrosilicon, alloys

Abstract

This article presents a microstructural analysis of details obtained in an electric furnace in a gray cast iron alloy. The samples poured into the sand-clay mold were studied using a scanning electron microscope, and it was important to determine the mechanical, physical and technological properties of the details through the obtained structures.

Downloads

Download data is not yet available.

References

Jose Antonio Pero-Sanz Elorz, Daniel Fernandez Gonzalez, Luis Felipe Verdeja Book “Physical metallurgy of cast irons” University of Oviedo, Asturias, Spain

https://materials-today.com/cast-iron-types-microstructure/

L. Collini, G. Nicoletto and R. Konecnc, Microstructure and mechanical properties of pearlitic gray cast iron, Mater. Sci. Eng.: A, Vol. 488, No. 1-2, (2008)

Carbide to Graphite Transition Control by Thermal Analysis in Grey Cast Irons Elena Loredana Neacsu, Iulian Riposan, Ana Maria Cojocaru, Stelian Stan and Iuliana Stan 23 July 2020

Effect of Temperature on Wear Characteristic of Cast Iron S. K. Shaha and M.M.Haque Conference Paper May 2010 DOI:10.31399/asm.cp.itsc2010p0741.

José Antonio Pero-Sanz Elorz Daniel Fernández González Luis Felipe Verdeja Physical Metallurgy of Cast Irons Springer Nature Switzerland AG 2018.

Y. Xia, S. Sasaki, H. Mano, T. Murakami and M. Nakano, Tribological Properties of Gray Cast Iron Lubricated with PAO and Amine Salt of Alkali Phosphate Additive, Tribo. On lin., Vol. 2, No. 3 (2007)

Odilov, E., & Mardonov, U. (2021). Effect of Magnetic Field on the Properties of Flowing Lubricating Cooling Liquids used in Manufacturing Process. International Journal on Orange Technologies, 3(12), 1-5.

Heidari, S. M. A. Boutorabi, and M. T. Honaramooz School of Metallurgy and Materials Engineering, Iran University of Science and Technology, Tehran, Iran “Ablation casting of thin-wall ductile iron”.